trouble setting up

[daveysgirl]

hi all you vtx men iv been having problems setting my bike up first i put hypercharger on .then big shot pipes with quiet baffles . it ran ok but poped back on shut off. iv now fitted power commander the dyno guy is one off the best in the country. he has had the bike and tried all ways to get it to run very smoth but at low speeds like roundbouts ect.it runs iraticley pulling and riding strong no problem and sounds fantastic . iv had the plugs out after a run and the back plug on each pot is running a bit rich but on dyno it raeds its running ok can anybody help

[Big Wes]

Just a suggestion Daveysgirl, I think I would go to power commander site and find a map that is close to your set up and download it into your pc3. http://www.powercommander.com Then perhaps you can tweak the map to sort of fine tune it, or at least have your dynoman tweak it for you. I would think that the dyno shop should have been able to get your bike to run smooth throughout all the power bands.

Like I said just a suggestion. You can also pm Bareass172 for some assistance. a very knowlable guy and always eager to help out. You can usually find him on the tech 1800 board

[daveysgirl]

Thanks for your suggestion, I'll give it a try.

[Big Wes]

Keep us posted with your progress and results. Thanks and Good Luck 8)