Honda VTX Forum banner

Cruise Pegs

882 views 13 replies 12 participants last post by  caswensk 
#1 ·
Poll time --

Whats everyones favorite cruise peg set up.
 
#4 ·
I went with the floorboards on my C. Got sick of my feet feeling like they were sliding off.
 
#6 ·
had a set of the Kury pegs but my legs interfered with the hyper charger. Now have a set of Kury swing-wing pegs,still getting used to them but seem to work well.
 
#8 ·
kury cruise pegs
 
#13 ·
I just purchased the Kuryakyn Switchblade footpegs. They are great. It is about the size of a ¾ floorboard but the back part flips out to become an extended peg to place your feet. If you order be sure to order the special adapter. It is different than the standard adaptors for Kuryakyn footpegs. I had to send the adaptors back to J&P Cycle and order directly from Kuryakyn
 
#14 ·
Jason G. said:
Hey caswensk, where can i purchase that setup? might just be what im looking for.
I peiced together a bunch of Kury parts. I hope I get the numbers right, but I think it was:



http://directlineparts.com/product.asp?pid=1343&str=12&ID=092370761

and


http://directlineparts.com/product.asp?pid=6088&str=12&ID=092370761

and


http://directlineparts.com/product.asp?pid=1914&str=12&ID=092370761
...in the 1.35" size.

I then had the spacer machined out of aluminum and polished to push the pegs out further, and then swapped the bolt out for a longer one. They were very uncomfortable without the spacer, but I can reach around the air cleaner just fine now.

The biggest seller for me was how rigid these are. I like the Kury mounts the others have mentioned, but they seem to move alot under your feet... I'm sure they're fine, but with any movement I swore I was going to snap one off when I sat on a bike that had them...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top