Honda VTX Forum banner

1300 Dyno-jet carb kit

399 views 2 replies 2 participants last post by  BD's Cycles 
#1 ·
I put a set of pipes (Cobra slash cut's?) and a jet kit (DJ stage 1) into a customers 1300 today. Buttoned it all back up but have not run it yet. I installed it just like the instructions called for, needle clip on 3rd from the top, washer on top of that, DJ spring, 2.5 turns out on the air screw, and the 195 main jet.

I'm hoping/anticipating it'll be fine, any of you guys have any other settings you are using?

I'm used to in-line 4cyl bikes, doing jet kits in those is, well, 4x the work! The single carb on the 1300 is a piece of cake!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top