Honda VTX Forum banner

F to N Conversion Update

2K views 17 replies 6 participants last post by  badbode 
#1 ·
Just got done spraying the 2nd coat of clear.
I want to wet sand it and put a couple more coats of clear then sand and buff.

How long does it need to cure before I wet sand it?

Before .........................My Progress
Fender
Automotive exterior Bumper Vehicle Fender Tire
 
See less See more
2
#11 ·
Most use this plate. http://www.radiantz.com/index1.html?10.html&1
If I were to do it again I would use this one. http://www.radiantz.com/index1.html?458.html&1

here is their line up of plate lighting http://www.radiantz.com/index1.html?c17.html&1

I would agree... I used the top one... Painted it to match my fender cuz it stuck out like a sore thumb. I "created" the second one by using flex strips on the side of my frame. I would use the second one if I had to do it again.
 
#12 ·
I would agree... I used the top one... Painted it to match my fender cuz it stuck out like a sore thumb. I "created" the second one by using flex strips on the side of my frame. I would use the second one if I had to do it again.
Have you or Kalten got any closeup pics. I'd like to see how it looks.
I had thought about using KURYAKYN 9171
http://www.kuryakyn.com/Products/482/Curved-Laydown
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top