Honda VTX Forum banner

Freeway bars installation

518 views 3 replies 3 participants last post by  Steamboat 
#1 ·
I ordered the Cobra freeway bars from Direct Line. When I tried to remove the right front floorboard bolt, it started spinning as though it was stripped.
I'm at work now and was wondering if there is a nut on the back side of that bolt that I should have had a wrench on?????
Any thoughts or suggestions are greatly appreciated.

Boat
 
#2 ·
On my C, there is a nut behind it that needs a wrench. The other side doesn't have one & comes out the way you're doing it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top