I recently installed apes with internal wiring on my bike... Flipped the key on, fired the bike right up and everything works great! However I am having a strange problem with my turn signals.
When i turn the switch for the left side, the turn signals work great, fronts have running lights and the back works perfectly on the right...
When I put the switch in the center, i notice the fronts running lights are working correctly, but the back rear right is showing amber and the indicator on my bike shows the right side turn signal light on. So the turn signal light is stuck on on the right side, and the turn signal light on the back is permanently activated..
When I switch over to the right side, the front right turn signal works (the light on the dash goes off completely not blinking), and the rear doesn't do anything...
Then when I put it back to the middle switch, the rear lights up again, the front works correctly and the dash light is permanently on.
The previous owner installed an LED integrated tail light that was working recently, but his wiring job sucks.
Any ideas? I am beyond frustrated!
When i turn the switch for the left side, the turn signals work great, fronts have running lights and the back works perfectly on the right...
When I put the switch in the center, i notice the fronts running lights are working correctly, but the back rear right is showing amber and the indicator on my bike shows the right side turn signal light on. So the turn signal light is stuck on on the right side, and the turn signal light on the back is permanently activated..
When I switch over to the right side, the front right turn signal works (the light on the dash goes off completely not blinking), and the rear doesn't do anything...
Then when I put it back to the middle switch, the rear lights up again, the front works correctly and the dash light is permanently on.
The previous owner installed an LED integrated tail light that was working recently, but his wiring job sucks.
Any ideas? I am beyond frustrated!