VTXOA - View Single Post - Batwing Amp Wiring
View Single Post
post #12 of (permalink) Old 02-19-2019, 12:45 AM
Daniel.Longnecker
Junior Member
 
Daniel.Longnecker's Avatar
 
Join Date: Dec 2018
Location: Fort Irwin, CA
Posts: 22
Garage
Quote:
Originally Posted by prkuehn View Post
Quote:
Originally Posted by JPT View Post
Thank you for all the information.



So is the suggestion to go back to a non-bridged setup? Also it install a system volt meter to monitgor the voltage levels so I can make sure I am adequately charging the system?



Thanks


I would leave the amp like it is, but adding a voltage indicator would take the guesswork out.

https://www.denniskirk.com/kuryakyn/...prd/406981.sku
Leaving 2 speakers in parallel across 2 channels will potentially damage your amplifier, especially if the voltage is dropping below 12v. The Amp is 4 ohm stable bridged, not 2 ohm. See my first post. Rewire to a stable load and if you can use an oscilloscope to tune the gain for a clean signal.

The only easy day was yesterday.
Daniel.Longnecker is offline  
 
 
For the best viewing experience please update your browser to Google Chrome