MRVTX - Page 2 - VTXOA
 10Likes
Reply
 
LinkBack Thread Tools
post #11 of 110 (permalink) Old 07-06-2008, 11:18 PM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
Re: MRVTX

56,044 miles

* Replaced shock bushings with McMaster Carr's Nylon Bearing, Sleeve for 5/8" Shaft Diameter, 7/8" O.D. 3/4" length - P/N: 6389K344
MR VTX is offline  
Sponsored Links
Advertisement
 
post #12 of 110 (permalink) Old 12-03-2008, 11:46 AM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
59,000 miles...11/08

* New fender (painted to match) was put on
* Invicta hardbags (painted to match) put back on
* Possum Pusher (painted to match) was put on
* Changed front brake pads
MR VTX is offline  
post #13 of 110 (permalink) Old 01-18-2009, 12:16 PM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
60,635 miles

* Replaced spark plugs after who knows how many miles. Runs much better now!
MR VTX is offline  
 
post #14 of 110 (permalink) Old 03-16-2009, 01:28 AM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
62,057 miles...3/15/09

* The blocked PAIR hose was cracked, so I fixed it by cutting off the cracked end and putting a smaller diameter bolt with a zip tie
* Lubed/adjusted clutch cable
* Oil/Filter change
* Final drive fluid change
* Changed fork oil
* Changed coolant
* Installed Speed Bleeders & bled front/rear brakes with new brake fluid
* Installed rear brake pads
* Tore down carb & thoroughly cleaned/replaced the following:
_____ Accelerator pump components that were corroded (16021-KBG-670)
_____ Float chamber gasket (16163-MEA-671)
* Polished fins; painted engine, carb & manifold using DupliColor 500-Degree Semi-Gloss Black
* Performed valve adjustment
* Re-tapped lower rear exhaust stud hole in rear cylinder & installed new exhaust stud
* Purchased new acorn nuts and used anti-seize compound on all four nuts
* Used Eagle One Nevr-Dull Wadding Polish on the exhaust to clean them up really well
* Replaced the following o-rings/washers/gaskets:
_____1. Timing hole cap - 1 (91301-ML7-003)
_____2. Oil dipstick - 1 (91307-425-003)
_____3. Final drive fill cap - 1 (91302-001-020)
_____4. Final drive sealing washer - 1 (94109-14000)
_____5. Fork cap - 2 (91356-KF0-003)
_____6. Cylinder oblong tappet cover - 2 (12392-HC4-005)
_____7. Cylinder round tappet cover - 2 (91303-KK3-830)
_____8. Exhaust crush gaskets - 2 (18291-MR5-801)
MR VTX is offline  
post #15 of 110 (permalink) Old 10-09-2009, 12:23 AM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
71,020 miles...10/08/09

* Oil/filter change (Amsoil 10w-40 & Amsoil filter)
MR VTX is offline  
post #16 of 110 (permalink) Old 10-15-2009, 12:07 AM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
71,200 miles - 10/14/09

* Changed out headlight bulb with SilverStar Ultra bulb (the bright on the old SilverStar burned out)
MR VTX is offline  
post #17 of 110 (permalink) Old 01-01-2010, 01:51 PM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
MR VTX is offline  
post #18 of 110 (permalink) Old 01-01-2010, 01:58 PM
Senior Member
 
Philscbx's Avatar
 
Join Date: Jun 2004
Location: Mpls, Mn
Posts: 9,836
Very Impressive.
So it's finally broken in.

[SIGPIC][/SIGPIC]
The Scoots 07 Neo III 03 18C ServMan Wiring Dia
Philscbx is offline  
post #19 of 110 (permalink) Old 01-02-2010, 03:29 AM Thread Starter
Senior Member
 
MR VTX's Avatar
 
Join Date: Nov 2003
Location: Magnolia, TX
Posts: 12,010
Garage
Quote:
Originally Posted by Philscbx View Post
Very Impressive.
So it's finally broken in.
...just about!
MR VTX is offline  
post #20 of 110 (permalink) Old 01-10-2010, 07:52 AM
Senior Member
 
Thunderduck's Avatar
 
Join Date: Jul 2008
Location: Orange Park, FL
Posts: 600
Wink

All that is very inpressive, hope someday you can afford to paint your fairing.

Max

[SIGPIC][/SIGPIC]
Retired US Navy, 2011 Victory Vision Tour, Crimson Red, XM Radio, Utopia Back Rest, Fairing Lowers, Electric Windshield, LED accent Lights, Dyna Beads, Bushtec Trailer and Hitch
Thunderduck is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the VTXOA forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome