|Topic Review (Newest First)|
|11-05-2019 10:28 PM|
Originally Posted by VTXArizona View Post
Good to know though.
|11-05-2019 08:42 PM|
|VTXArizona||you do realize you can buy an new air filter housing for around $40 shipped, right?|
|11-05-2019 08:09 PM|
Originally Posted by StarrRider View Post
Problem solved without glue. The broken plastic/rubber grommet was so tight, that even with metal piece in place all the way, which took awhile for me to get it in there, still cracked part not totally closed. I had to use a hammer to bang metal piece in there. Cover is totally flush. Did not over tighten. Don't think the metal piece is going anywhere.
|11-05-2019 12:18 AM|
Originally Posted by maurice2 View Post
Then install the metal piece in the hole on the back cover. If you have already glued it you will have to break the glue before the metal piece will fit in the hole. It is a tight fit before it's glued together.
That metal piece is an anchored nut, and is molded into the plastic back cover.
Look at the other cover screws and see how they are screwed into the back cover. That's how it is supposed to be.
|11-04-2019 09:00 PM|
|maurice2||No luck. The black piece in the housing is glued well together, but the chrome piece does not go in that hole. Too small a hole. Look at the pic of the flat metal piece on chrome cover, then look at the hole when clamped together. big difference. I must be missing something here. Like what Hans said maybe the metal piece should be in the housing to start with, so I have to get the piece out of the chrome cover? I will need to break the bond that is glued though.|
|11-04-2019 08:57 PM|
Originally Posted by Hans&Feet View Post
|11-04-2019 05:41 PM|
|Chicago-Spike||Yep, it's broken, and the fluid is the blowby from the crankcase vent hose. Clean the clear tube on the back of the airbox oout as that is supposed to catch that oil residue until it's filled then it will spill out of the bottom of the airbox.|
|11-04-2019 08:23 AM|
|rangers4u||^^^^THIS^^^^ is what I did too. Works great. Fuel line skinny worm drive hose clamps fit right in there.|
|11-04-2019 01:07 AM|
|StarrRider||Instead of using glue I used a small screw type fuel hose clamp to squeeze it together around the threaded metal part. It's been working for a couple years now. The clamp is inside of the box and doesn't interfere with the filter.|
|11-03-2019 10:00 PM|
Did you remove the part from the chrome cover and re-install it into the back cover.
Than put the glue on??
Very light torque when tightening.
|This thread has more than 10 replies. Click here to review the whole thread.|