Honda VTX Forum banner
loose
1-2 of 2 Results
  1. VTX 1800 Tech Board
    Hi All, I just pulled off my rear wheel to replace my rear flange/bearing with one that was remanufactured by Jon's1800VTXC. As I got ready to start cranking off the nuts that hold the flange to the hub I noticed there is movement in the hub -- quite a bit. Is this normal or something I need...
  2. VTX 1300 Riders Board
    I recently installed a new OE boulevard shield and it seems like I can't get it tight enough. I can grab the shield and actually move it up down on the rubber mounts. It doesn't rattle while going over bumps and I'm afraid to torque it any tighter. Has anyone come across this issue before or is...
1-2 of 2 Results
Top