[Hans&Feet]

A few diagrams for PAIR and California Evaporative Emissions System.

https://www.vtxoa.com/attachments/vacuum-hose-routing-diagram-jpg.31884/

 

[captvelcro]

Hey thanks for your help on that other thread, H&F. I thought I'd just bring it over here to ask: does the air vent control valve need to be connected to anything on a desmogged 04 1300R/S?.

If it doesn't then all my problems go away bc I can connect the ACV with the intake manifold and petcock with the 1 t-joint between the heads.

Apologies for being a nuisance. I def should have paid more attention in shop class.

 

[07Blackcherry]

That is exactly how the 49 state bikes that have been desmogged are hooked up.

 

[Chicago-Spike]

bump

 

[Hans&Feet]

Dragged over from some other thread regarding CA emission hoses.
EVAP removal on CA 1300s
Post #27 has the emissions and pair vacuum layout.
https://www.vtxoa.com/attachments/vacuum-hose-routing-diagram-jpg.31884/
#10 is the vacuum source from intake manifold to PAIR to EVAP control valve
and to ACO.
ACO and petcock need vacuum... ACO has 2 screws on diaphragm.

Fuel tank vent tube hangs in the breeze after removing the EVAP canister.
The upper body has outside air for the on the 49 state with a very short hose.
it allows air into carb body when slide valve goes up--- between step 4 and 5
of Carb 101 next to fuel hose. A tiny spring clip.
MR VTX carb 101 Carb Cleaning 101

Most everything else could be plugged... MY Guess...

 

[Hans&Feet]

An early thread with PIX..

CA Emissions Removal Howto

So, if you have a california VTX 1300 and you want to remove the EVAP system along with the PAIR system off of your bike, here are a few steps: Get the bike up on a stand (makes getting the evap canister off easier) Remove your seat and tank. Remove the evap canister that is held on by two...

www.vtxoa.com