Honda VTX Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
100 Posts
Discussion Starter · #1 ·
Can anyone confirm the wire color to tap into. The ICM pin outs show that the Blue/Yellow and Yellow/Blue go to the front and rear ignition coil, and the Black/White run up to Engine stop switch.

Which of these wires (or other if I am just too dumb to see it) is the ignition coil (-) to use for the tach signal?

Please advise!
joe
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top