Honda VTX Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
191 Posts
Discussion Starter #1
I just got an Ultimate Lowrider and am using it with the stock passeneger seat. I would like to stud it and the backrest pad to match the Ultimate and my saddle bags. How hard is it to remove the seat cushion, install the studs and, most importantly put the seat back together? The backrest pad looks like it just unzips so that shouldn't be hard at all. But the seat looks like it is stapled. Is it hard to get back into place right? Are the staples just the common 1/2 inchers from a standard staple gun?
 

·
Registered
Joined
·
1,268 Posts
Every time I ride............ba dum bum
Thank you, thank you very much
I'll be here all week
try the fish
:twisted:
 

·
Registered
Joined
·
1,262 Posts
Use the search option at the top of the page. I was last spring or summer that someone posted how to do this. I followed the directions to stud the passenger backrest (to match my mustang seat) it was easy. just take your time when doing the layout so yo don't poke any unwanted holes in the seat.

Good luck,
Brock
 

·
Registered
Joined
·
191 Posts
Discussion Starter #5
Thanks guys, I found the posts from last year. The local hobby store had the nickel studs in the right size to match, 7/16". Now I just need the time to do it.
 
1 - 5 of 5 Posts
Top