Honda VTX Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
I have an 03 Retro and accidentally yank out the the breather tube that enters the backbone near the rubber fuel tank mounts on the left side :oops: . I looked around and can't find where it connects to. Does any one know where it goes to? This the same breather hose that connects to the fuel tank with a tee fitting and exits by the coolant tank.

-BGP
 

·
Registered
Joined
·
110 Posts
breather tube?

If the hose you are talking about is approx. 1/4" diameter it is probably the vent hose that goes to the gas tank on the 1800.

Were you working under the tank on the left side?

Good luck

Steve t
 

·
Registered
Joined
·
22 Posts
Discussion Starter #4
Re: breather tube?

Steve T said:
If the hose you are talking about is approx. 1/4" diameter it is probably the vent hose that goes to the gas tank on the 1800.

Were you working under the tank on the left side?

Good luck

Steve t
It's not the fuel tank breather hose... that is connected to the tank. If you follow that hose from the tank it goes to a "tee" fitting. From the "tee" fitting a 1/4" hose runs along the backbone towards the front of the bike and enters a hole on the left side of the backbone. This is the hose that got pulled out and looking to see where it goes back to.

-BGP
 

·
Super Moderator
Joined
·
63,762 Posts
That will be the drain tube for the tank vent. It comes out behind the battery under the frame. 8)
 
1 - 5 of 5 Posts
Top