Honda VTX Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
7,340 Posts
Discussion Starter #1
Getting ready to install my LED engine lights. I hooked all of them up to my VOM just to see what kind of draw I was going to have. At 13.2V on my lawnmower batt, they pulled .82 amp. I don't think this is going to be a problem, but would like to get others opinions... 8)
 

·
Registered
Joined
·
7,141 Posts
Thats less then 11 watts , less then your brake light so nothing to worry about.
 

·
Super Moderator
Joined
·
63,774 Posts
I have well over 2 dozen LED pods all over my X. LEDs draw milli-amps and are nothing to worry about. I've accidently left them on over a weekend and the bike started right up. 8)
 

·
Registered
Joined
·
7,340 Posts
Discussion Starter #4
silvervtx04s said:
Thats less then 11 watts , less then your brake light so nothing to worry about.
Well, not less than my brake light, that's LED from the factory.
 

·
Registered
Joined
·
7,141 Posts
Sandman333 said:
silvervtx04s said:
Thats less then 11 watts , less then your brake light so nothing to worry about.
Well, not less than my brake light, that's LED from the factory.
OK Less then a standard tail light bulb.... :wink:
 
1 - 6 of 6 Posts
Top