Honda VTX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
937 Posts
Discussion Starter #1
I got my bike a month ago and noticed there was a bunch of wires sticking out of sub cover.
While adjusting shifter rod (I installed Paladin Bars) I hid all the
wires (which were wrapped in some kind of tape) under the Sub Cover.
My question is that will Engine Casing melt this wire harness?
Should I return wires where they were previously?
Do they belong under the Sub Cover?
Thank you all.

 

·
Registered
Joined
·
937 Posts
Discussion Starter #3
Bareass172 said:
There should be no wires sticking out there, they all belong under that side cover. You're safe. :wink:
Bare,
Thanks a bunch! as always!
 
1 - 3 of 3 Posts
Top