Honda VTX Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
367 Posts
Isn't the MAP wire the one that you had to cut. I believe you have to remove your tank and reconnect it where it was cut at the sensor. I have been through this myself. Call me if you want to discuss it. I'm pretty sure I can figure it out for you. 864 225 3699.
 

· Registered
Joined
·
367 Posts
The yellow/red wire from you ECU goes to the MAP sensor. When the HPP was installed, that wire was cut about three inches from the sensor and taped up (not used). the three inches left at the sensor was then connected to a wire from the HPP. You need to go to the MAP sensor, find where the HPP wire is connected to yellow/red wire on the MAP sensor, find the taped up yellow/red wire from the factory wiring harness near the MAP sensor and reconnect the two yellow/red wires. This will connect the MAP sensor back to the ECU. DO NOT try to connect the MAP directly to the ECU. It want work, trust me. I'll explain later but its to complicated for a slow typist like me to type out.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top