Honda VTX Forum banner

1 - 20 of 54 Posts
H

·
Guest
Joined
·
0 Posts
Discussion Starter #1
This is the "First article" of production. Still need to determine the angle of the cut on the 2 intakes but they are looking real good.

 

·
Registered
Joined
·
615 Posts
Are these cast and machined or machined from billet?
 

·
Registered
Joined
·
1,554 Posts
Me thinks they are machined.

very nice.
 

·
Registered
Joined
·
37 Posts
Will you mass produce, or will it be a first come, first served order basis?

Also, have you come up with a ballpark price yet? I'm looking at a hypercharger, but would rather wait for one of these!

Thanks,
Chuck
 
H

·
Guest
Joined
·
0 Posts
Discussion Starter #9
Will you mass produce, or will it be a first come, first served order basis?

Also, have you come up with a ballpark price yet? I'm looking at a hypercharger, but would rather wait for one of these!

Thanks,
Chuck
No pricing yet.

Need to get it to the chromer so we can see what that is going to be. We are probably into February before we can start to ship and take orders.
 

·
Registered
Joined
·
958 Posts
cool! why not cut angle same as kewlmetal tip?...




me think it'll look cool???:dontknow:

oh yeah can u get one special made for me such as black anonized or just send me blank.. I can get it sent over to get it black???

Thanks...:thumbup:
 

·
Registered
Joined
·
669 Posts
cool! why not cut angle same as kewlmetal tip?...




me think it'll look cool???:dontknow:

oh yeah can u get one special made for me such as black anonized or just send me blank.. I can get it sent over to get it black???

Thanks...:thumbup:
That would be sweet.
 

·
Registered
Joined
·
1,998 Posts
cool! why not cut angle same as kewlmetal tip?...
what would be cool was if the intakes were machined to fit the tips
themselves and held in place by a couple hidden set screws.

then you could swap out tips of any style you wanted ...
 

·
Registered
Joined
·
61 Posts
what would be cool was if the intakes were machined to fit the tips
themselves and held in place by a couple hidden set screws.

then you could swap out tips of any style you wanted ...
Agree! That would be most excellent!

-eSlon
 

·
Registered
Joined
·
6,803 Posts
SWEEET!

ME LIKE!!!:thumbup:
 

·
Registered
Joined
·
10,672 Posts
Put some Flat socket head cap screws in it... The normal socket head cap screws you have in it make it look like the guy drawing the part got lazy, "unfinished design". Sorry some things just stick out like a sore thumb.
 

·
Registered
Joined
·
983 Posts
How would you get out the water, from when riding in the rain (I'm sure it will go right in there) and from condensation... will there be a drain on the bottom?
 
1 - 20 of 54 Posts
Top