Honda VTX Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2,073 Posts
Discussion Starter · #1 ·
Well I managed to do a couple of things today on my bike that I am sure I would not have even attempted if it was not for this board. I did the pare valve removal with that block off plates that I picked up from VTXnNH. Leon I just want to say thanks for the plates and the pointers when doing the job. I reviewed all the links here, on the tech garage site and the bare site to make sure I didn't miss anything and it seems to have gone just about perfect. I even knew enough to check the crankcase vent after I put the breather back on to make sure it was working (A VERY GOOD THING TO KNOW!!!!!). I also pulled my 4" areomach risers off and replaced with my stock risers so that I can still ride the bike while aftershock and I trade risers. I by no means have any valueable bike knowledge but with the help of this board and the people I have met from it I have no fear in touching any thing on my bike. Next stop valve and carb jetting Yee HAAAA :D :D

Thanks Everyone

Ken
 
1 - 1 of 1 Posts
Top