Honda VTX Forum banner
1 - 6 of 6 Posts

·
Old Goat
Joined
·
26,260 Posts
Discussion Starter · #1 ·
I installed my ms lowers today and was looking for pics to see the sweet spot. I know I need to ride it and I will just wanted to see what you did. Thanks for any replies and have a safe one.
 

·
Registered
Joined
·
886 Posts
These are the only pics I have that show the lowers...somewhat.

I made my own and decided to cover as much area as possible.
They start behind the windshield about an inch overlap.



 

·
Registered
Joined
·
459 Posts
dang, did you ride your bike in that snow??? and how did you position the lowers behind the blinkers??? i had to put my lowers just below the blinkers because they were in the way.
 

·
Old Goat
Joined
·
26,260 Posts
Discussion Starter · #5 ·
wildcat5415 said:
dang, did you ride your bike in that snow??? and how did you position the lowers behind the blinkers??? i had to put my lowers just below the blinkers because they were in the way.
Thanks for the replies (must not be a poplar subject :lol: ) On my bike I have a 2" headlight ext. it allowed me to do my own light bar and put the lowers where I want.
 

·
Registered
Joined
·
886 Posts
Actually is was barely coming down when I left for work. The pavement was a little damp. Those pics were taken 1 1/2 hours after I got to work. The snow melted before I left work to go home.

At Home Depot I got a 1" nylon spacer and a new bolt (1 1/2" stainless).
Took off the old bolt and put in the new one. This pushed the turn signal bar forward 1".
 
1 - 6 of 6 Posts
Top