Honda VTX Forum banner
1 - 3 of 3 Posts

494 Posts
Discussion Starter · #1 ·
I put this up last week but the only response I got was to gut the pipes.
This is not an option IMO. I plan on drilling a 3/4 to 1" hole at about 6 o'clock on each pipe. Depending on the sound, I may take a 3/4" long bit and go right down the existing exhaust pipe as well :twisted: .

Question, has anyone done either of these or both and what were the results? I'd really like to get some feedback on this if anyone has done this or knows of someone who did.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.