Honda VTX Forum banner
1 - 3 of 3 Posts

828 Posts
Discussion Starter · #1 ·
Getting ready to put the scooter back together this weekend. Sent the aluminum out to be polished.

So, when I replace the drive-shaft, do I need to put lube on the ends of the shaft itself? As in, the end that goes into the transmission, and/or the end that slides into the final drive hub?

If so, what do I use? Moly Paste? Oil?

Moly Paste!! The Honda one works just fine.

Tapper loves this job...I got him some rubber gloves, but he don’t put them on, I tell ya this stuff sticks to your fingers……hehehe

1 - 3 of 3 Posts